Characteristics of Cu and Mo-doped Ca3Co4O9-delta cathode materials for use in solid oxide fuel cells
|
|
【文章作者】Wang, Sea-Fue;Hsu, Yung -Fu;Chang, Jing-Han;Cheng, Soofin;Lu, Hsi-Chuan |
【文章摘要】 In this study, Cu and Mo ions were doped in Ca3Co4O9-delta to improve the electrical conductivity and electrochemical behavior of Ca3Co4O9-delta ceramic and the performance of a solid oxide fuel cell (SOFC) single cell based on NiO-SDC/SDC/doped Ca3Co4O9-delta-SDC were examined. Cu substitution in the monoclinic Ca3Co4O9-delta ceramic effectively enhanced the densification, slightly increased the grain size, and triggered the formation of some Ca3Co2O6; however, no second phase was found in porous Mo-doped Ca3Co4O9-delta ceramics even when the sintering temperature reached 1050 degrees C. Substitution of Cu ions caused slight increase in the Co3+ and Co4+ contents and decrease in the Co2+ content; however, doping with Mo ions showed the opposite trend. Doping the Ca3Co4O9-delta ceramic with a small amount of Cu or Mo increased its electrical conductivity. The maximum electrical conductivity measured was 218.8 S cm(-1) for the Ca3Co3.9Cu0.1O9-delta ceramic at 800 degrees C. The Ca3Co3.9Cu0.1O9-delta ceramic with a coefficient of thermal expansion coefficient of 12.1 x 10(-6) K-1 was chosen as the cathode to build SOFC single cells consisting of a 20 mu m SDC electrolyte layer. Without optimizing the microstructure of the cathode or hermetically sealing the cell against the gas, a power density of 0.367 Wcm(-2) at 750 degrees C was achieved, demonstrating that Cu-doped Ca3Co4O9-delta can be used as a potential cathode material for IT-SOFCs. (C) 2016 Elsevier Ltd and Techna Group S.r.l. All rights reserved. |
【关 键 字】 |
【卷】42 【ISSUE】9 【ISSUEID】815C0073
【文章期份】2016
【发布日期】2016/8/11 17:04:15
点击率:1
打印
关闭
|
|