| 【文章摘要】 Cooled in water after isothermal relaxation of deformed austenite for different times, an Nb-bearing microalloyed steel always exhibits synthetic microstructures, in which bainitic ferrite dominates. Dislocation configurations and distributions of strain induced precipitates inside bainitic ferrite of samples relaxed for different times were distinct. When compared with the austenite model steel, which maintained fcc structure even at room temperature, the strain induced precipitates were not found in the sample without relaxation whereas these were distributed outside dislocations in sample relaxed for 1000s. Most of the strain induced precipitates distribute along dislocations and pin dislocations in sample relaxed for appropriate time. After bainitic transformation, the dislocations formed in deformed austenite remain to be pinned by the precipitates. When these samples were reheated to and held at 650 or 700℃, the non-equilibrious microstructures tended to evolve into equilibrious ones. The sample relaxed for 60s displayed the highest thermo-stability, whereas microstructure evolution was the quickest in the sample relaxed for 1000s even though it was the softest prior to reheating. Dislocations inside laths got rid of pinning of precipitates, and their polygonization became the precursor to the evolution of microstructures during reheated and held, followed by gradual disappearance of lath boundaries caused by dislocation climbing. Finally, recrystallization occurred and polygonal ferrite appeared. By hardness measurement, it was found that softening is not a single process occurring during reheated, in which hardness fluctuates with time. There were two peaks in the hardness-time curve of each sample having undergone relaxation, while single peak occured in the curve of the sample not being relaxed. These results indicated that the thermo-stability of microstructures was determined by their history of formation to a considerable degree. |